Supported Cisco Ios Commands - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

NM-CIDS Configuration Tasks

Supported Cisco IOS Commands

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-86
Cisco Systems Intrusion Detection System Network Module
Software version: 4.1(1)S42(0.3)
Model: NM-CIDS
Memory: 254676 KB
The following Cisco IOS command is new to support the NM-CIDS:
service-module ids-sensor
The slot number can vary, but the port is always 0. These options are available:
• reload
reset
•
• session
shutdown
•
status
•
The following Cisco IOS commands are supported on the NM-CIDS:
Privileged mode EXEC
•
– service-module ids-sensor slot_number/0 reload
Router#
Reloads the operating system on the NM-CIDS.
service-module ids-sensor slot_number/0 reset
–
Router#
Provides a hardware reset to the NM-CIDS.
service-module ids-sensor slot_number/0 session
–
Router#
Entering Console for IDS sensor Module in slot slot_number.
The session command allows you access to the IDS console.
Chapter 10 Configuring the Sensor Using the CLI
slot_number/
0
78-15597-02