Four-Post Rack Installation; Recommended Tools And Supplies; Rack Kit Contents; Installing The Slide Assemblies - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 5 Installing the IDS-4235 and IDS-4250

Four-Post Rack Installation

Caution

Recommended Tools and Supplies

Rack Kit Contents

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
You can install your appliance in a four-post rack (part number IDS-RAIL-4=).
Do not install rack kit components designed for another system. Use only the rack
kit for your appliance. Using the rack kit for another system may damage the
appliance and cause injury to yourself and others.
This section contains these topics:
• Recommended Tools and Supplies, page 5-23
Rack Kit Contents, page 5-23
•
• Installing the Slide Assemblies, page 5-24
• Installing the Appliance in the Rack, page 5-26
Installing the Cable-Management Arm, page 5-28
•
• Routing the Cables, page 5-32
You need these tools and supplies to install the appliance in a four-post rack
cabinet:
#2 Phillips screwdriver
•
Masking tape or felt-tip pen for marking the mounting holes to be used
•
The four-post rack kit includes these items:
One pair of slide assemblies
•
• One cable-management arm
One stop block
•
• One status-indicator cable assembly
Ten 10-32 x 0.5-inch flange-head Phillips screws
•
Releaseable tie wraps
•
Installing the Accessories
5-23