Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 284

IDSM-2 Configuration Tasks
Configuring the Catalyst 6500 Series Switch for Command and
Control Access to the IDSM-2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-88
Perform the other initial tasks, such as adding users, trusted hosts,
5.
configuring the sensor to use an NTP server as a time source, and so forth.
See Sensor Initial Configuration Tasks, page
6. Configure intrusion detection.
See Sensor Configuration Tasks, page
documentation. See the Cisco Intrusion Detection System (IDS) Hardware
and Software Version 4.1 Documentation Guide that shipped with your
IDSM-2 for instructions on how to locate these documents.
Perform miscellaneous tasks to keep your IDSM-2 running smoothly.
7.
See Sensor Administrative Tasks, page
page 10-98, for more information.
8. Upgrade the IDS software with new signature updates and service packs.
See Obtaining Cisco IDS Software, page
Reimage the application partition and the maintenance partition when
9.
needed.
See Reimaging the IDSM-2, page
This section contains the following topics:
Configuring the Catalyst 6500 Series Switch for Command and Control
•
Access to the IDSM-2, page 10-88
Capturing IDS Traffic, page 10-90
•
Miscellaneous Tasks, page 10-98
•
After you initialize the IDSM-2, you must configure the Catalyst 6500 series
switch to have command and control access to the IDSM-2.
Chapter 10 Configuring the Sensor Using the CLI
10-2, for more information.
10-35, and IDS manager
10-24, and Miscellaneous Tasks,
9-1, for more information.
10-124.
78-15597-02