Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 76

Removing and Replacing the Chassis Cover
Lower the front of the top panel onto the chassis, making sure that the top panel
Step 3
side tabs fit under the chassis side panels.
Step 4 Slide the top panel toward the front, making sure that the top panel tabs fit under
the chassis back panel and the back panel tabs fit under the top panel.
Fasten the top panel with the screws you set aside earlier.
Step 5
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
3-16
POWER ACT NETWORK
POWER ACT NETWORK
Chapter 3 Installing the IDS-4215
CISCO IDS-4215
Intrusion Detection Sensor
CISCO IDS-4215
Intrusion Detection Sensor
78-15597-02