Replacing The Chassis Cover - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 3 Installing the IDS-4215

Replacing the Chassis Cover

Caution
Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
POWER ACT NETWORK
Do not operate the IDS-4215 without the chassis cover installed. The chassis
cover protects the internal components, prevents electrical shorts, and provides
proper air flow for cooling the electronic components.
To replace the chassis cover, follow these steps:
Place the chassis on a secure surface with the front panel facing you.
Hold the top panel so the tabs at the rear of the top panel are aligned with the
chassis bottom.
Removing and Replacing the Chassis Cover
CISCO IDS-4215
Intrusion Detection Sensor
3-15