Rebooting Or Powering Down The Appliance - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Sensor Administrative Tasks
Step 6
Step 7

Rebooting or Powering Down the Appliance

Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-30
sensor# show events past
The following example displays all events beginning 30 seconds in the past.
sensor# show events past 00:00:30
Delete events from the event store:
sensor# clear events
Warning: Executing this command will remove all events currently
stored in the event store.
Continue with clear? :
Type yes to clear all events from the EventStore.
The reset command stops the applications running on the appliance and reboots
it. If the powerdown option is included, the appliance is powered off if possible
or left in a state where the power can be turned off after the applications are
stopped.
Shutdown (stopping the applications) begins immediately after the command is
executed. Because shutdown may take a little time, you can continue to access
CLI commands (access is not denied) but access can be terminated without
warning.
See Rebooting the NM-CIDS, page
page 10-101, for the procedure for the modules.
To reboot or power down the appliance, follow these steps:
Log into the CLI using an account with administrator privileges.
To stop all applications and reboot the appliance, follow these steps:, otherwise,
to power down the appliance, skip to Step 3.
Reset the appliance:
a.
sensor# reset
A warning appears:
Chapter 10 Configuring the Sensor Using the CLI
hh:mm:ss
10-83, and Resetting the IDSM-2,
78-15597-02