Sensor Administrative Tasks; Displaying The Current Version And Configuration Information - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Sensor Administrative Tasks

Step 6
Sensor Administrative Tasks

Displaying the Current Version and Configuration Information

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-24
router(config)# ntp source
For example:
router(config)# ntp source FastEthernet 1/0
Type the NTP master stratum number to be assigned to the sensor:
router(config)# ntp master
For example:
router(config)# ntp master 6
The NTP master stratum number identifies the server's relative position in the
NTP hierarchy. You can choose a number between 1 and 15. It is not important to
the sensor which number you choose.
This section describes the administrative tasks for the sensor.
This section contains the following topics:
Displaying the Current Version and Configuration Information, page 10-24
•
• Creating and Using a Backup Configuration File, page 10-28
Displaying and Clearing Events, page 10-28
•
• Rebooting or Powering Down the Appliance, page 10-30
Displaying Tech Support Information, page 10-31
•
Displaying and Clearing Statistics, page 10-33
•
You can display the IDS software version and sensor configuration. Use the show
version command to display version information for all installed operating
system (OS) packages, signature packages, and IDS processes running on the
system. To view the configuration for the entire system, use the more
current-config command.
Chapter 10 Configuring the Sensor Using the CLI
interface-name
stratum-number
78-15597-02