Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 98

Installing the IDS-4220 and IDS-4230
Attach the network cables.
Step 4
•
•
Step 5 Upgrade the memory on the appliance.
See
Caution You must upgrade the memory on the IDS-4220 to a minimum of 512 MB before
you can install the most recent Cisco IDS software version.
Power on the appliance.
Step 6
Initialize your appliance.
Step 7
See
Upgrade your appliance to the most recent Cisco IDS software.
Step 8
See
Assign the interfaces.
Step 9
See
You are now ready to configure intrusion detection on your appliance.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
4-8
Command & Control Interface: int1
I
O
COM 1
Keyboard
Monitor
int0 is the sensing port.
int1 is the command and control port.
Upgrading the Memory, page
Initializing the Sensor, page
Obtaining Cisco IDS Software, page
Assigning and Enabling the Sensing Interface, page
Chapter 4
Sniffing Interface: int0
2-3, for the procedure.
10-2, for the procedure.
9-1, for the procedure.
Installing the IDS-4220 and IDS-4230
10-9, for the procedure.
78-15597-02