Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 115

Chapter 5 Installing the IDS-4235 and IDS-4250
Caution Be sure to read the safety warnings in the Regulatory Compliance and Safety
Information for the Cisco Intrusion Detection System 4200 Series Appliance
Sensor and follow proper safety procedures when performing the following steps.
Note None of the PCI cards are supported as a command and control interface.
The IDS-4250 supports only one of the following cards in a PCI slot: the SX card
Caution
(upper PCI slot), the XL card (upper PCI slot), or the 4FE card (lower PCI slot).
The IDS-4235 supports only the 4FE card in the lower PCI slot.
To install the PCI card, follow these steps:
Log in to the CLI.
Step 1
Prepare the appliance to be powered off:
Step 2
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
Note
Power off the appliance.
Step 3
Step 4 Remove the power cord and other cables from the appliance.
Place the appliance in an ESD-controlled environment.
Step 5
See
Step 6 Remove the cover.
a.
b.
c.
d.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
You can also power down the sensor from IDM or IDS MC.
Working in an ESD Environment, page
Remove the single screw at the front of the chassis.
Press the chassis release button to release the left side of the cover.
Use the tab at the rear of the system to lift the left side of the cover.
Use the tab at the rear of the system to lift the right side of the cover.
Installing the Accessories
1-21, for more information.
5-17