Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 318

Reimaging Appliances and Modules
Note
The Helper utility is launched:
Cisco Systems, Inc.
Services engine helper utility for NM-CIDS
Version 1.0(1) [200305011547]
——-
Main menu
1 - Download application image and write to HDD
2 - Download bootloader and write to flash
3 - Display software version on HDD
4 - Display total RAM size
5 - Change file transfer method (currently secure shell)
Change file transfer method (currently secure shell)
r - Exit and reset Services Engine
h - Exit and shutdown Services Engine
Selection [1234rh]:
Step 10 Chose the transfer method:
Set SSH as the transfer method:
Step 11
Step 12 Reimage the hard-disk drive:
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-122
After the helper image is loaded, the bootloader checks that it downloaded
correctly. The bootloader will not run a helper if it was received
incorrectly or it was not signed by Cisco. The following message
indicates the helper is valid:
For SSH, go to Steps 11 and 12.
a.
For TFTP, go to Steps 13 and 14.
b.
Type 5.
a.
b. Type 1 to change to secure shell.
Type r to return to the Main menu.
c.
a. Type 1.
Type the secure shell server username.
b.
c. Type the secure shell server IP address.
Type the full pathname of recovery image:
d.
full pathname of recovery image: /path /NM-CIDS-K9-a-4.1-1-S42.bin
Chapter 10 Configuring the Sensor Using the CLI
Image signature verified successfully.
78-15597-02