Table of Contents
Advertisement
Installing the Accessories
Routing the Cables
Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
5-32
To route the cables, follow these steps:
Attach the I/O cable connectors to their respective connectors on the appliance
back panel.
For details on the cable connections, see
page
5-9.
Route the power and I/O cables through the cable-management arm, using four
loosely secured releaseable tie-wraps (two in the middle and on each end of the
cable-management arm).
Note
Do not fully tighten the tie-wraps at this time (see
page
5-33). Allow some cable slack in the cable-management arm to
prevent damage to the cables.
Chapter 5
Installing the IDS-4235 and IDS-4250
Installing the IDS-4235 and IDS-4250,
Figure 5-11 on
78-15597-02
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor and is the answer not in the manual?
Questions and answers