Table of Contents
Advertisement
Chapter 8
Installing the IDSM-2
Caution
Do not touch the printed circuit boards or connector pins on the IDSM-2.
Step 6
Place the IDSM-2 in the slot by aligning the notch on the sides of the IDSM-2
carrier with the groove in the slot.
Step 7
Keeping the IDSM-2 at a 90-degree orientation to the backplane, carefully push
it into the slot until the notches on both ejector levers engage the chassis sides.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Installation and Removal Instructions
8-9
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor and is the answer not in the manual?
Questions and answers