Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 56

Installing the Accessories
Locate one of the two brackets and align it over the two threaded holes on the side
Step 3
of the appliance (see
Figure 2-2
Phillips screws
Secure the bracket to the appliance chassis using two screws (see
Step 4
Repeat Step 4 to install the remaining bracket on the other side of the appliance.
Step 5
Step 6 Lift the appliance into position between the two posts with the hole in the
mounting bracket aligned one hole above the mark you made in the two posts (see
Figure
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
2-10
Figure
Installing Center Mount Brackets
Pan-head
LINK
100 Mbp s
LINK 100 Mbp
s
CON S
ETH ERN ET
0 ETH ERN
ET 1
2-2).
2-2).
DRI VE 0
DRI VE 1
SCS I LVD ONL
Y
DRI VE 0
DRI VE 1
Chapter 2 Installing the IDS-4210
Pan-head
Phillips screws
(2 per bracket)
Figure 2-2).
78-15597-02