Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 336

System Components
MainApp responds to the show version command by displaying the following
information:
•
•
•
•
•
•
•
MainApp also gathers the host statistics.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
A-10
Stop IDS applications in the reverse order specified in static
4.
configuration.
An interrupt signal is sent to each application telling it to shut down.
5. Wait for an exit evStatus event from each application.
If after waiting 60 seconds all status events have not been received,
mainApp generates an error message and continues.
Close evStatus event subscription.
6.
7. Start the utility that waits for MainApp to exit before triggering the OS
to shut down.
8. Destruct shared system components—EventStore and IDAPI.
9. Exit MainApp.
Reboot the operating system.
10.
A system reboot is functionally the same as a system shutdown
Note
except the OS is triggered to reboot.
Sensor build version
MainApp version
Version of each running application
Version and timestamp of each installed upgrade
Next downgrade version of each installed upgrade
Platform version (for example, IDS-4240, WS-SVC-IDSM2)
Version of sensor build on the other partition
Appendix A Intrusion Detection System Architecture
78-15597-02