Table of Contents
Advertisement
Chapter 10
Configuring the Sensor Using the CLI
h.
i.
j.
k.
l.
m.
n.
o.
p.
Type 2 to save the configuration.
Step 14
Enter your selection[2]: 2
Configuration Saved.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Specify the month you want summertime settings to end.
The default is oct.
Valid entries are jan, feb, mar, apr, may, jun, jul, aug, sep, oct, nov, and dec.
Specify the week you want the summertime settings to end.
The default is last.
Valid entries are first, second, third, fourth, fifth, and last.
Specify the day you want the summertime settings to end.
The default is sun.
Valid entries are sun, mon, tue, wed, thu, fri, and sat.
Specify the time you want summertime settings to end.
The default is 02:00:00.
Specify the DST zone.
The zone name is a character string up to 128 characters long.
Specify the summertime offset.
The default is 60.
Specify the summertime offset from UTC in minutes (negative numbers
represent time zones west of the Prime Meridian).
Type yes to modify the system time zone.
Specify the standard time zone name.
The zone name is a character string up to 128 characters long.
Specify the standard time offset.
The default is 60.
Your configuration appears with the following options:
[0] Go to the command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration and exit setup.
Sensor Initial Configuration Tasks
10-7
Advertisement
Table of Contents
Troubleshooting
