Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 86

Removing and Installing the 4FE Card
See
Step 6 Remove the chassis cover.
See
Step 7 Loosen the single captive screw that holds the 4FE card's connecting flange to the
back cover plate.
Step 8 Loosen the two captive screws from the back cover on the left and put the back
cover aside.
Step 9 Grasp the 4FE card and pull it out of the slot and through the cage opening.
Step 10 Replace the lower slot cover from the back cover plate.
Replace the back cover plate and tighten the two captive screws.
Step 11
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
3-26
Working in an ESD Environment, page
Removing the Chassis Cover, page
Chapter 3 Installing the IDS-4215
1-21, for more information.
3-13, for the procedure.
78-15597-02