Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 82

Removing and Replacing the Compact Flash Device
Note
Power off the appliance.
Step 3
Step 4 Remove the power cord and other cables from the appliance.
Step 5 Place the appliance in an ESD-controlled environment.
See
Step 6 Remove the chassis cover.
See
Remove the hard-disk drive.
Step 7
See
Grasp the compact flash device and carefully remove it from the connector on the
Step 8
riser card.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
3-22
You can also power down the sensor using IDM or IDS MC.
Working in an ESD Environment, page
Removing the Chassis Cover, page
Removing the Hard-Disk Drive, page
Chapter 3 Installing the IDS-4215
1-21, for more information.
3-13, for the procedure.
3-18, for the procedure.
78-15597-02