Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 324

Reimaging Appliances and Modules
Step 3
Step 4
Step 5
Cisco IOS Software
Step 1
Step 2
Step 3
Step 4
Step 5
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-128
Enter configuration mode:
sensor# configure terminal
Reimage the maintenance partition:
sensor# upgrade
user@ftp_server_IP_address/directory_path/image_file
ftp://
You are asked whether you want continue.
Type y to continue.
The maintenance partition file is upgraded.
To reimage the maintenance partition, follow these steps:
Obtain the maintenance partition file from Software Center on Cisco.com and
copy it to an SCP or FTP server.
See Obtaining Cisco IDS Software, page
Software Center on Cisco.com.
Log in to the switch CLI.
Session in to the application partition CLI:
cat6k# session slot
Enter configuration mode:
cat6k# configure terminal
Reimage the maintenance partition:
cat6k(config)# upgrade
user@ftp_server_IP_address
ftp://
Chapter 10
9-1, for instructions on how to access the
slot_number
processor 1
directory_path
/
Configuring the Sensor Using the CLI
image_file
/
78-15597-02