Network Modules; Hardware Bypass Network Modules - Cisco Firepower 4100 Series Manual

10-Gb Network Module
For More Information
10-Gb Network Module
The following figure shows the front panel of the 10-Gb network module (FPR4K-NM-8X10G). The
FPR4K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
Note
Note
Note
Overview
12
• See 10-Gb Network Module, on page 12
• See 40-Gb Network Module, on page 13
• See 100-Gb Network Module (Two Ports, Single Wide), on page 14
100-Gb network module.
• See 100-Gb Network Module (Four Ports, Single Wide), on page 15
100-Gb network module.
• See Hardware Bypass Network Modules, on page 16
and the port configurations for the hardware bypass network modules.
• See Install, Remove, and Replace the Network Module

network modules.

Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the Cisco Firepower 4100/9300 FXOS Firmware Upgrade
FXOS Compatibility for the software compatibility matrix.
The FPR4K-NM-8X10G is NEBS-compliant.
You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be
populated at the same time, because of the port row spacing.
for a description of the 10-GB network module.
for a description of the 40-GB network module.
for a description of the two-port
for a description of the four-port
for the location and description of the LEDs,
for the procedure for removing and replacing
Guide. See
Overview
Cisco Firepower 4100/9300