Table of Contents
Advertisement
Chapter 6
Installing the IPS-4240 and IPS-4255
•
•
Power on the appliance.
Step 7
Initialize your appliance.
Step 8
See
Upgrade your appliance with the most recent Cisco IDS software.
Step 9
See
Step 10
Assign the interfaces:
See
Note
You are now ready to configure intrusion detection on your appliance.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
LINK SPD
LINK SPD
3
INT0 through INT3 are sensing ports.
MGMT is the command and control port.
Initializing the Sensor, page
Obtaining Cisco IDS Software, page
Assigning and Enabling the Sensing Interface, page
The interfaces are disabled by default.
Installing the IPS-4240 and IPS-4255
LINK SPD
LINK SPD
2
1
0
10-2, for the procedure.
9-1, for the procedure.
10-9, for the procedure.
6-11
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor and is the answer not in the manual?
Questions and answers