Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 161

Chapter 7 Installing the NM-CIDS
or UTP cable
The following warning applies to routers that use a DC power supply:
After wiring the DC power supply, remove the tape from the circuit breaker
Warning
switch handle and reinstate power by moving the handle of the circuit breaker
to the ON position.
Step 8 Connect the command and control port to a hub or switch.
Check that the NM-CIDS indicators light up, and that the Active/Ready indicators
Step 9
on the front panel also light up.
Initialize the NM-CIDS.
Step 10
See
Upgrade your NM-CIDS to the latest Cisco IDS software.
Step 11
See
Step 12 Assign the interfaces.
See
You are now ready to configure intrusion detection on your NM-CIDS.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
NM-CE- BP
Category 5
Initializing the Sensor, page
Obtaining Cisco IDS Software, page
Assigning and Enabling the Sensing Interface, page
DISK
LINK
ACT
EN
PWR
FastEther net 0
Fast Ethernet
RJ-45
10-2, for the procedure.
9-1, for the procedure.
Installation and Removal Instructions
CF
Fast Ethernet hub
10-9, for the procedure.
7-9