Table of Contents
Advertisement
Troubleshooting the 4200 Series Appliance
Step 6
Logging
Enabling Debug Logging
Caution
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
B-28
If the remote MBS sensor is using TLS for web access, make sure the forwarding
sensor is configured as a TLS host:
Enter configuration mode:
a.
sensor# configure terminal
Make the forwarding sensor a TLS host:
b.
sensor(config)# tls trust ip
TAC may suggest that you turn on debug logging for troubleshooting purposes.
LogApp controls what log messages are generated by each application by
controlling the logging severity for different logging zones. By default, debug
logging is not turned on.
If you enable individual zone control, each zone uses the level of logging that it
is configured for. Otherwise, the same logging level is used for all zones.
This section contains the following topics:
•
Enabling Debug Logging, page B-28
Zone Names, page B-31
•
Directing cidLog Messages to SysLog, page B-31
•
Enabling debug logging seriously affects performance and should only be done
when instructed by TAC.
Appendix B
master_blocking_sensor_ip_address
Troubleshooting
78-15597-02
Advertisement
Table of Contents
Troubleshooting
