Installing Spare Hard-Disk Drives - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Installing Spare Hard-Disk Drives

Installing Spare Hard-Disk Drives
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
5-6
Table 5-2 IDS-4235 and IDS-4250 Specifications
Dimensions and Weight
Height
Width
Depth
Weight
Form factor
Power
Autoswitching
Frequency
Operating current
Maximum heat dissipation
Environment
Temperature
Relative humidity
Do not install a second hard-disk drive in the IDS-4235 and IDS-4250. The spare
hard-disk drives are meant to replace the original hard-disk drives and are not
meant to be used in conjunction with the original hard-disk drive. If you install
two hard-disk drives in the appliance, the appliance may not recognize the
recover command used to reimage the appliance.
If the original hard-disk drive becomes unusable, remove the hard-disk drive and
insert the replacement hard-disk drive. See
Hard-Disk Drive, page
The replacement hard-disk drive is shipped blank from the factory. You must
reimage it. See Reimaging the Appliance, page
Chapter 5
1.67 in. (4.24 cm)
17.6 in. (44.70 cm)
27.0 in. (68.58 cm)
35 lb (15.88 kg)
1 RU, standard 19-inch rack-mountable
110V to 220 VAC
50 to 60 Hz, single phase
2.7A at 115V
1.3A at 220V
983 Btu/hr (maximum)
Operating +50° to +95°F (+10° to +35°C)
Nonoperating -40° to 149°F (-40° to 65°C)
Operating 8 to 80% (noncondensing)
Nonoperating 5 to 95% (noncondensing)
Removing and Replacing the SCSI
5-20, for the procedure.
Installing the IDS-4235 and IDS-4250
10-110, for the procedure.
78-15597-02