Rebooting The Nm-Cids - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 10 Configuring the Sensor Using the CLI

Rebooting the NM-CIDS

Caution
Caution
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
The Cisco IOS provides the following commands to control the NM-CIDS:
shutdown, reload, and reset:
shutdown—Brings the operating system down gracefully:
•
Router# service-module ids-sensor slot_number/0 shutdown
Make sure you execute a shutdown command before you remove the hard-disk
drive from the NM-CIDS. Failing to do so can lead to the loss of data or the
corruption of the hard-disk drive.
• reload—Performs a graceful halt and reboot of the operating system on an
NM-CIDS:
Router# service-module ids-sensor slot_number/0 reload
• reset—Resets the hardware on the NM-CIDS. Typically this command is used
to recover from a shutdown.
Router# service-module ids-sensor slot_number/0 reset
The following warning appears:
Router# service-module ids-sensor 1/0 reset
Use reset only to recover from shutdown or failed state
Warning: May lose data on the hard disc!
Do you want to reset?[confirm]
Hard-disk drive data loss only occurs if you issue the reset command without first
shutting down the NM-CIDS. You can use the reset command safely in other
situations.
NM-CIDS Configuration Tasks
10-83