Adding Trusted Hosts - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Sensor Initial Configuration Tasks
Step 3
Step 4

Adding Trusted Hosts

Step 1
Step 2
Step 3
Step 4
Step 5
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-18
Remove the user:
sensor(config)# no username
The username is now removed from the sensor.
Verify that the user has been removed.
a. Exit configuration mode:
sensor(config)# exit
b. View a list of all users:
sensor# show users all
A list of all user accounts is displayed. The user you removed no longer
appears in the list.
You can identify hosts (trusted hosts) that are allowed to connect to the sensor.
To add a trusted host, follow these steps:
Log in to the CLI using an account with administrator or operator privileges.
Enter configuration mode:
sensor# configure terminal
Enter Service host mode:
sensor(config)# service host
Enter configuration mode for network parameters:
sensor(config-Host)# networkParams
Specify the allowed host:
sensor(config-Host-net)# accessList ipAddress
The IP address is now in the list of trusted hosts.
Chapter 10 Configuring the Sensor Using the CLI
name
ip_address
78-15597-02