Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 311

Chapter 10 Configuring the Sensor Using the CLI
Verify that the sensor is running BIOS version 5.1.7 or later and ROMMON
Step 4
version 1.4 or later.
The current versions are shown in the console display information identified in
Step 3.
Select the interface port number to be used for the TFTP download:
Step 5
Note
rommon> interface <port_number>
Note Ports 0 and 1 are labeled on the back of the chassis.
Set an IP address for the local port on the IDS-4125:
Step 6
rommon> ip_address <ip_address>
Note
Step 7 Set the TFTP server IP address:
rommon> server <ip_address>
Step 8 Set the gateway IP address:
rommon> gateway <ip_address>
Verify that you have access to the TFTP server by pinging it from your local
Step 9
defined Ethernet port using one of the following commands:
rommon> ping <ip_address>
rommon> ping server
Define the path and filename on the TFTP file server from which you are
Step 10
downloading the image:
rommon> file <path/filename>
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
The port in use is listed just before the rommon prompt. In the example,
port 1 is being used as noted by the text,
dev:14 irq:11), MAC: 0000.c0ff.ee01
Select an unused IP address on the sensor's local network that can access
the TFTP server.
Reimaging Appliances and Modules
Using 1: i82557 @ PCI(bus:0
.
10-115