Sensing Interfaces - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 10 Configuring the Sensor Using the CLI
Step 4

Sensing Interfaces

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Exit interface group configuration mode:
d.
sensor(config-ifg)# exit
To enable or disable an interface, follow these steps:
Enter sensing interface configuration mode for the interface:
a.
sensor(config)# interface sensing
Where name is the logical name of the sensing interface, such as int0.
b. Enable the interface:
sensor(config-ifs)# no shutdown
Verify the interface is enabled:
c.
sensor(config-ifs)# exit
sensor(config)# exit
sensor# show interface
Disable the interface:
d.
sensor# configure terminal
sensor(config)# interface sensing name
sensor(config-ifs)# shutdown
Exit sensing interface configuration mode:
e.
sensor(config-ifs)# exit
sensor(config)# exit
sensor#
Note Enabling or disabling the interface group enables or disables all
sensing interfaces contained in the group.
Table 10-1 on page 10-12
name
lists the sensing interfaces for each IDS platform.
Sensor Initial Configuration Tasks
10-11