Table of Contents
Advertisement
Chapter 5
Installing the IDS-4235 and IDS-4250
Figure 5-8
Cable-Management Arm
Step 5
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
The stop block prevents the backward travel of the cable-management
Note
arm and supports the weight of the arm with its load of installed cables.
The two-post rack kit has two stop blocks: one for right-side mounting,
Note
and one for left-side mounting. You can only install the proper stop block.
Install the status-indicator cable plug into its connector (see
page
5-30).
Installing the Accessories
Figure 5-9 on
5-29
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor and is the answer not in the manual?
Questions and answers