Table of Contents
Advertisement
Chapter 10
Configuring the Sensor Using the CLI
Sensor Configuration Tasks
SigComment:
SigName: Back Door (UDP 2140) <protected>
SigStringInfo: UDP 2140 (backdoor) <defaulted>
SigVersion: S37 <defaulted>
SrcIpAddr:
SrcIpMask:
SrcPort:
StorageKey: xxxx <defaulted>
SummaryKey: AxBx <defaulted>
ThrottleInterval: 30 <defaulted>
WantFrag:
-----------------------------------------------
SIGID: 9020 <protected>
SubSig: 0 <protected>
AlarmDelayTimer:
AlarmInterval:
AlarmSeverity: informational <defaulted>
AlarmThrottle: FireOnce <defaulted>
AlarmTraits:
CapturePacket: False <defaulted>
ChokeThreshold: 100 <defaulted>
DstIpAddr:
DstIpMask:
DstPort: 47262 <defaulted>
Enabled: False <defaulted>
EventAction:
FlipAddr:
MaxInspectLength:
MaxTTL:
MinHits:
MinUDPLength:
Protocol: UDP <defaulted>
ResetAfterIdle: 15 <defaulted>
ShortUDPLength:
SigComment:
SigName: Back Door (UDP 47262) <protected>
SigStringInfo: UDP 47262 (backdoor) <defaulted>
SigVersion: S37 <defaulted>
SrcIpAddr:
SrcIpMask:
SrcPort:
StorageKey: xxxx <defaulted>
SummaryKey: AxBx <defaulted>
ThrottleInterval: 30 <defaulted>
WantFrag:
-----------------------------------------------
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-47
78-15597-02
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor and is the answer not in the manual?
Questions and answers