Catalyst Software; Cisco Ios Software - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 10 Configuring the Sensor Using the CLI

Catalyst Software

Step 1
Step 2
Step 3
Step 4

Cisco IOS Software

Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
This section contains the following topics:
• Catalyst Software, page 10-89
Cisco IOS Software, page 10-89
•
To configure the Catalyst 6500 series switch to have command and control access
to the IDSM-2, follow these steps:
Log in to the console.
Enter privileged mode:
Console> enable
Put the command and control port into the correct VLAN:
Console> (enable) set vlan
module_slot_number
/
Example:
Console> (enable) set vlan 147 8/2
Verify that you have connectivity by sessioning into the IDSM-2:
Console> session slot
network_ip_address
ping
To configure the Catalyst 6500 series switch to have command and control access
to the IDSM-2, follow these steps:
Log in to the console.
Enter configuration mode:
Router# configure terminal
command_and_control_vlan_number
command_and_control_port_number
module_number
IDSM-2 Configuration Tasks
10-89