Step 1 - Install The Disk Drives - Cisco NSS2000 Series Getting Started Manual

Setting up the Hardware
Step 1 — Install the Disk Drives
Step 1 — Install the Disk Drives
STEP 1
STEP 2
STEP 3
NSS2000 Getting Started Guide
After you remove the NSS from the packaging, you are ready to set up the
hardware. If your NSS already has disk drives installed, skip this step.
To install the disk drives into the NSS:
Remove a disk tray from the front of the NSS chassis by pushing in the tab on the
latch at the front of the tray then open the latch. (There is no recommended order
of which tray to remove first.)
a
Position the disk drive into a disk tray.
Using a Phillips screwdriver, either screw in two screws on each side of the disk
tray to the disk drive or screw in the four screws on the bottom of the disk tray to
the disk drive.
b
OR
2
4