Mld Snooping Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The MLD snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config mld_snooping
config mld_snooping mrouter_ports
enable mld_snooping
disable mld_snooping
show mld_snooping
show mld_snooping group
show mld_snooping forwarding
show mld_snooping mrouter_ports
Each command is listed, in detail, in the following sections.
config mld_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
Parameters
[ <vlan_name 32> |all] { node_timeout <sec 1-16711450> | router_timeout
<sec 1-16711450> | done_timer <sec 1-16711450> | state
[enable|disable] | fast_done [enable|disable] }
<vlan_name 32> [add|delete]<portlist>
{forward_mcrouter_only}
{forward_mcrouter_only}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>} { [static|dynamic]}
Used to configurer MLD snooping on the switch.
config mld_snooping [ <vlan_name 32> |all] { node_timeout <sec
1-16711450> | router_timeout <sec 1-16711450> | done_timer
<sec 1-16711450> | state [enable|disable] | fast_done
[enable|disable] }
The config mld_snooping command configures MLD snooping on the
switch.
vlan_name - The name of the VLAN for which MLD snooping is to be
configured.
all - Specifies that all VLANs configured on the switch will be
configured.
node_timeout - Specifies the amount of time that must pass before a
link node is considered to be not a listener anymore. The default is
260 seconds.
router_timeout - Specifies the maximum amount of time a router will
remain in the switch's can be a listener of a multicast group without
the switch receiving a node listener report. The default is 260
seconds.
done_timer - Specifies the maximum amount of time a group will
remain in the switch after receiving a done message of the group
without receiving a node listener report. The default setting is 2
seconds.
state - Allows you to enable or disable the MLD snooping function for
the chosen VLAN.
fast_done - enable or disable MLD snooping fast_done function.If
enable, the membership is immediately removed when the system
receive the MLD done message.
Only Administrator or Operator-level users can issue this command.
417
MLD S
NOOPING
60
C
OMMANDS