D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 225

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
show ospf neighbor
Parameters
Restrictions
Usage example:
To display the current OSPF neighbor router table:
DES-3800:admin#show ospf neighbor
Command: show ospf neighbor
IP Address of
Neighbor
--------------
10.48.74.122
Total Entries: 1
DES-3800:admin#
show ospf virtual_neighbor
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To display the current OSPF virtual neighbor table:
DES-3800:admin#show ospf virtual_neighbor
Command: show ospf virtual_neighbor
Transit
Area ID
-------
10.1.1.1
Total Entries : 1
DES-3800:admin#
config ospf ipif
Purpose
Syntax
<ipaddr> − The IP address of the neighbor router.
None.
Router ID of
Neighbor
--------------
10.2.2.2
Used to display the current OSPF virtual neighbor router table.
show ospf virtual_neighbor {<area_id> <neighbor id>}
This command will display the current OSPF virtual neighbor router
table.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<neighbor_id> − The OSPF router ID for the neighbor. This is a 32-bit
number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the remote area's Area Border Router.
None.
Router ID of
Virtual Neighbor
-----------
10.2.3.4
Used to configure the OSPF interface settings.
config ospf [ipif <ipif_name 12> | all] {area <area_id> | priority
<value> | hello_interval <sec 1-65535> | dead_interval <sec 1-
65535> | authentication [none | simple <password 8> | md5 <key_id
1-255>] | metric <value 1-65535> | state [enable | disable] | active |
Neighbor Neighbor
Priority State
-------- ------------
1 Initial
IP Address of
Virtual Neighbor
--------------
10.48.74.111
221
Virtual Neighbor
State
----------------
Exchange