Igmp Snooping Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config igmp_snooping
config igmp_snooping querier
config router_ports
enable igmp_snooping
show igmp_snooping
disable igmp_snooping
show igmp snooping group
show router_ports
show igmp_snooping forwarding
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Parameters
[<vlan_name 32> | all] {host_timeout <sec 1-16711450> | router_timeout
<sec 1-16711450> | leave_timer <sec 0-16711450> | state [enable |
disable] | fast_leave [enable | disable]}
[<vlan_name 32> | all] {query_interval <sec 1-65535> |
max_response_time <sec 1-25> | robustness_variable <value 1-255> |
last_member_query_interval <sec 1-25> | state [enable | disable]}
<vlan_name 32> [add | delete] <portlist>
{forward_mcrouter_only}
{vlan <vlan_name 32>}
{forward_mcrouter_only}
vlan <vlan_name 32>
{vlan <vlan_name 32>} {static | dynamic}
{vlan <vlan_name 32>}
Used to configure IGMP snooping on the Switch.
config igmp_snooping [<vlan_name 32> | all] {host_timeout <sec 1-
16711450> | router_timeout <sec 1-16711450> | leave_timer <sec 0-
16711450> | state [enable | disable]} | fast_leave [enable | disable]}
This command allows users to configure IGMP snooping on the Switch.
<vlan_name 32> − The name of the VLAN for which IGMP snooping is to be
configured.
host_timeout <sec 1-16711450> − Specifies the maximum amount of time a
host can be a member of a multicast group without the Switch receiving a
host membership report. The default is 260 seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount of time
a route can be a member of a multicast group without the Switch receiving a
host membership report. The default is 260 seconds.
leave_timer <sec 1-16711450> − Specifies the amount of time a Multicast
address will stay in the database before it is deleted, after it has sent out a
leave group message. An entry of zero (0) specifies an immediate deletion
of the Multicast address. The default is 2 seconds.
state [enable | disable] − Allows users to enable or disable IGMP snooping
for the specified VLAN.
fast_leave [enable | disable] – This parameter allows the user to enable the
fast leave function. Enabled, this function will allow members of a multicast
group to leave the group immediately (without the implementation of the
Last Member Query Timer) when an IGMP Leave Report Packet is received
by the Switch.
Only Administrator or Operator-level users can issue this command.
IGMP S
123
17
C
NOOPING OMMANDS