D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 235

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config time_zone
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure time zone settings:
config dst
Purpose
Syntax
Description
DES-3800:admin#config time 30jun2003 16:30:30
Command: config time 30jun2003 16:30:30
Success.
DES-3800:admin#
Used to determine the time zone used in order to adjust the system
clock.
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
This will adjust system clock settings according to the time zone.
Time zone settings will adjust SNTP information accordingly.
operator – Choose to add (+) or subtract (-) time to adjust for time
zone relative to GMT.
hour – Select the number of hours different from GMT.
min – Select the number of minutes difference added or subtracted
to adjust the time zone.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#config time_zone operator + hour 2 min
30
Command: config time_zone operator + hour 2 min 30
Success.
DES-3800:admin#
Used to enable and configure time adjustments to allow for the use of
Daylight Savings Time (DST).
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day
<start_day sun-sat> | s_mth <start_mth 1-12> | s_time start_time
hh:mm> | e_week <end_week 1-4,last> | e_day <end_day sun-sat> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 |
90 | 120]} | annual {s_date start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]}]
DST can be enabled and configured using this command. When enabled
this will adjust the system clock to comply with any DST requirement. DST
adjustment effects system time for both manually configured time and time
set using SNTP service.
231