D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 270

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config authen server_host
Restrictions
Example usage:
To configure a TACACS+ authentication server host, with port number 4321, a timeout value of 12 seconds and a retransmit
count of 4.
DES-3800:admin#config authen server_host 10.1.1.121
protocol tacacs+ port 4321 timeout 12 retransmit 4
Command: config authen server_host 10.1.1.121 protocol
tacacs+ port 4321 timeout 12 retransmit 4
Success.
DES-3800:admin#
delete authen server_host
Purpose
Syntax
Description
Parameters
xtacacs - Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+ - Enter this parameter if the server host utilizes the
TACACS+ protocol.
radius - Enter this parameter if the server host utilizes the
RADIUS protocol.
port <int 1-65535> - Enter a number between 1 and 65535 to define the
virtual port number of the authentication protocol on a server host. The
default port number is 49 for TACACS/XTACACS/TACACS+ servers and
1812 and 1813 for RADIUS servers but the user may set a unique port
number for higher security.
key <key_string 254> - Authentication key to be shared with a configured
TACACS+ or RADIUS server only. Specify an alphanumeric string up to
254 characters or choose none.
timeout <int 1-255> - Enter the time in seconds the Switch will wait for the
server host to reply to an authentication request. The default value is 5
seconds.
retransmit <int 1-255> - Enter the value in the retransmit field to change
how many times the device will resend an authentication request when the
server does not respond. This field is inoperable for the TACACS+
protocol.
Only Administrator-level users can issue this command.
Used to delete a user-defined authentication server host.
delete authen server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius]
This command is used to delete a user-defined authentication
server host previously created on the Switch.
server_host <ipaddr> - The IP address of the remote server host to
be deleted.
protocol – The protocol used by the server host to delete. The user
may choose one of the following:
tacacs – Enter this parameter if the server host utilizes the
TACACS protocol.
xtacacs - Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+ - Enter this parameter if the server host utilizes the
TACACS+ protocol.
radius - Enter this parameter if the server host utilizes the
266