Loopback Interface Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The loopback interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table
Command
create loopback ipif
delete loopback ipif
config loopback ipif
show loopback ipif
Each command is listed, in detail, in the following sections.
create loopback ipif
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To create IP address 172.19.10.20 in loopback interface named loopback0.
Parameters
<ipif_name 12> <ipaddr> {state [enable | disable]}
[<ipif_name 12> | all]
<ipif_name 12> {ipaddress <ipaddr> | state [enable | disable]}
{<ipif_name 12>}
Used to create a loopback interface.
create loopback ipif <ipif_name 12> <ipaddr> {state [enable |
disable]}
The create ipif command creates an IP interface on the switch.
Loopback interface is a network termination and can't be direct
connected to the host. That is the host talks with loopback interface by
routing.
ipif - The name for the IP interface to be created. Maximum length is
12.
ipaddr - The IP address of this loopback interface. The netmask is
always 255.255.255.255
state - Allows you to enable or disable the loopback interface.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin# create loopback ipif loopback0
172.19.10.20
Command: create loopback ipif loopback0 172.19.10.20
Success.
DES-3800:admin#
L I
OOPBACK
398
C
NTERFACE OMMANDS
58