D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 80

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
create syslog host
Restrictions
Example usage:
To create syslog host:
DES-3800:admin#create syslog host 1 ipaddress 10.1.1.1
state enable
Command: create syslog host 1 ipaddress 10.1.1.1 state
enable
Success.
DES-3800:admin#
17 local use 1 (local1)
18 local use 2 (local2)
19 local use 3 (local3)
20 local use 4 (local4)
21 local use 5 (local5)
22 local use 6 (local6)
23 local use 7 (local7)
local0 − Specifies that local use 0 messages will be sent to the remote host.
This corresponds to number 16 from the list above.
local1 − Specifies that local use 1 messages will be sent to the remote host.
This corresponds to number 17 from the list above.
local2 − Specifies that local use 2 messages will be sent to the remote host.
This corresponds to number 18 from the list above.
local3 − Specifies that local use 3 messages will be sent to the remote host.
This corresponds to number 19 from the list above.
−
Specifies that local use 4 messages will be sent to the remote host.
local4
This corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages will be sent to the remote host.
This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages will be sent to the remote host.
This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages will be sent to the remote host.
This corresponds to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that the
syslog protocol will use to send messages to the remote host.
ipaddress <ipaddr> − Specifies the IP address of the remote host where
syslog messages will be sent.
state [enable | disable] − Allows the sending of syslog messages to the
remote host, specified above, to be enabled and disabled.
Only Administrator or Operator-level users can issue this command.
76