D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 332

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
enable address_binding acl_mode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable IP-MAC Binding ACL mode on the Switch:
disable address_binding acl_mode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable IP-MAC Binding ACL mode on the Switch:
Used to enable the ACL mode for an IP-MAC binding entry.
enable address_binding acl_mode
This command, along with the disable address_binding acl_mode will
enable and disable the ACL mode for IP-MAC binding on the Switch,
without altering previously set configurations. When enabled, the Switch
will automatically create two ACL packet content mask entries that can be
viewed using the show access_profile command. These two ACL entries
will aid the user in processing certain IP-MAC binding entries created.
None.
Only Administrator or Operator-level users can issue this command.
The ACL entries created when this command is enabled, can only be
automatically installed if the Access Profile table has two entries available
of the possible 9 entries allowed. These access profile entries can only be
deleted using the disable address_binding acl_mode and NOT though
the delete access_profile profile_id command. Also, the show config
command will not display the commands for creating the IP-MAC ACL
mode access profile entries.
DES-3800:admin#enable address_binding
acl_mode
Command: enable address_binding acl_mode
Success.
DES-3800:admin#
Used to disable the ACL mode for an IP-MAC binding entry.
disable address_binding acl_mode
This command, along with the enable address_binding acl_mode
will enable and disable the ACL mode for IP-MAC binding on the
Switch, without altering previously set configurations. When
disabled, the Switch will automatically delete two previously created
ACL packet content mask entries that can be viewed using the show
access_profile command.
None.
Only Administrator or Operator-level users can issue this command.
The ACL entries created when this command is enabled, can only
be automatically installed if the Access Profile table has two entries
available of the possible 9 entries allowed. These access profile
entries can only be deleted using the disable address_binding
acl_mode and NOT though the delete access_profile profile_id
command. Also, the show config command will not display the
commands for creating the IP-MAC ACL mode access profile
entries.
328