Md5 Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The MD5 configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create md5 key
config md5 key
delete md5 key
show md5
Each command is listed, in detail, in the following sections.
create md5 key
Purpose
Syntax
Description
Parameters
Restrictions
Usage example
To create an entry in the MD5 key table:
config md5 key
Purpose
Syntax
Description
Parameters
Restrictions
Usage example
To configure an MD5 Key password:
Parameters
<key_id 1-255> <password 16>
<key_id 1-255> <password 16>
<key_id 1-255>
{key <key_id 1-255>}
Used to create a new entry in the MD5 key table.
create md5 key <key_id 1-255> <password 16>
This command is used to create an entry for the MD5 key table.
<key_id 1-255> − The MD5 key ID. The user may enter a key ranging
from 1 to 255.
<password> − An MD5 password of up to 16 bytes.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin# create md5 key 1 dlink
Command: create md5 key 1 dlink
Success.
DES-3800:admin#
Used to enter configure the password for an MD5 key.
config md5 key <key_id 1-255> <password 16>
This command is used to configure an MD5 key and password.
<key_id 1-255> − The previously defined MD5 key ID.
<password 16> − The user may change the MD5 password for the
md5 key. A new password of up to 16 characters can be created.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#config md5 key 1 taboo
Command: config md5 key 1 taboo
209
32
MD5 C
OMMANDS