Switch Utility Commands; Command Parameters - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The download/upload commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
download
config firmware image_id
show firmware information
show config
config configuration
upload
ping
traceroute
config pkt_to_cpu
zero_ttl_ip
show pkt_to_cpu
Each command is listed, in detail, in the following sections.
download
Purpose
Syntax
Description
Parameters
Parameters
[firmware_fromTFTP <ipaddr> <path_filename 64> {image_id <1-2>}
| configuration <ipaddr> <path_filename 64> {config_id <1-2> | increment}]
<int 1-2> [delete | boot_up]
[current_config | config_in_nvram <config_id 1-2> | information]
<config_id 1-2> [boot_up | active | delete]
[cfg_toTFTP| log_toTFTP] <ipaddr> <path_filename 64> {config_id <1-2>}
<ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
<ipaddr> {ttl <value 1-60> | port <value 30000-64900> | timeout <sec 1-
65535> | probe <value <1-9>
state
Used to download and install new firmware or a Switch
configuration file from a TFTP server.
download [firmware_fromTFTP<ipaddr> <path_filename 64>
{image_id <1-n>}
| configuration <ipaddr> <path_filename 64> { config_id <1-2> |
increment}]
This command is used to download a new firmware or a Switch
configuration file from a TFTP server.
firmware_fromTFTP- download and install new firmware on the
switch from a TFTP server.
configuration- download a switch configuration file from a TFTP
server.
ipaddr- The IP address of the TFTP server.
path_filename- The DOS path and filename of the firmware or
switch configuration file on the TFTP server. The maximum length
is 64.
image_id <1-n> - Specifys the image identify number of the
indicated firmware. n is the maximum support number of image
which can be stroed and it's product dependent; this parameter will
available while dual image is supported,if the switch does not
support dual image, this parameter should not included in this
command. In this product, n = 2.
config_ id <1-2> - There are two level of download configuration
(a) Apply to system only when the config_ id is omitted.
(b) Save to flash but not apply to system if configuration ID is
58
S U
WITCH TILITY
9
C
OMMANDS