D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 277

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config accounting type
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the system accounting state:
Enter the old password:
Enter the case-sensitive new password:******
Enter the new password again for
confirmation:******
Success.
DES-3800:admin#
Used to configure the accounting feature of the Switch, which will employ a
remote RADIUS server to collect information regarding events occurring on
the Switch.
config accounting type [exec | system] state [enable | disable]
This command will employ a remote RADIUS server to collect information
regarding events occurring on the Switch. Possible switch events which will
trigger the sending of information to the RADIUS server once this feature is
enabled are as follows:
- Account Session ID
- Account Status Type
- Account Terminate Cause
- Account Authentic
- Account Delay Time
- NAS Identifier
This command is dependant on the configuration of a RADIUS server, both
on the Switch, and remotely, so that the RADIUS server has the proper
configurations to both collect and process the information that is being
relayed to it by the Switch.
type – Choose the type of accounting that the Switch will use. The user
may choose one of the following two choices.
•
exec – When enabled, the Switch will send informational packets
to a remote RADIUS server when a user either logs in, logs out
or times out on the Switch, using the console, Telnet or SSH.
•
system – When enabled, the Switch will send informational
packets to a remote RADIUS server when system events occur
on the Switch, such as a system reset or system boot.
state [enable | disable] – Choose whether to enable or disable the
accounting type previously chosen.
Only Administrator-level users can issue this command.
DES-3800:admin#config accounting type system
state enable
Command : config accounting type system state
enable
Success.
DES-3800:admin#
- Account Session Time
- Username
- Service Type
- NAS IP Address
- Calling Station ID
273