D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 45

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config snmp engineID
Restrictions
Example usage:
To configure the SNMP engineID:
DES-3800:admin#config snmp engineID 1023457890
Command: config snmp engineID 1023457890
Success.
DES-3800:admin#
show snmp engineID
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the snmp engine id:
DES-3800:admin#show snmp engineID
Command: show snmp engineID
SNMP Engine ID : 1023457890
DES-3800:admin#
create snmp group
Purpose
Syntax
Description
Parameters
Only Administrator or Operator-level users can issue this command.
Used to display the identification of the SNMP engine on the switch.
show snmp engineID
The show snmp engineID command displays the identification of the
SNMP engine on the switch. The default value is suggested in
RFC2271. The very first bit is 1, and the first four octets are set to
the binary equivalent of the agent's SNMP management private
enterprise number as assigned by IANA, D_Link is 171. The fifth
octet is 03 to indicates the rest is the MAC address of this device.
th th
The 6 –11 octets is MAC address.
None.
None.
Used to create a new SNMP group, or a table that maps SNMP
users to SNMP views
create snmp group <groupname> [v1 | v2c | v3 [noauth_nopriv |
auth_nopriv | auth_priv]]{read_view <view_name> | notify_view
<view_name> | notify_view <view_name>}
The create snmp group command creates a new SNMP group.
groupname- The name of the group.
v1- The least secure of the possible security models.
41