D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 408

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config dhcp pool network_addr
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To config address range of the DHCP address pool :
Specifies the network for the DHCP pool.
config dhcp pool network_addr <pool_name 12>
<network_address>
Specifies the network for the DHCP pool. The addresses in the
network are free to be assigned to the DHCP client..
The prefix length specifies the number of bits that comprise the
address prefix. The prefix is an alternative way of specifying the
network mask of the client. The prefix length must be preceded by a
forward slash (/). When the DHCP server receives a request from the
client, the server will automatically find a pool to allocate the address.
If the request is relayed to the server by the intermediate device, the
server will match the gateway IP address carried in the packet against
the network of each DHCP pool. The pool which has the longest
match will be selected. If the request packet is not through relay, then
the server will match the IP address of the IPIF that received the
request packet against the network of each DHCP pool.
<pool_name 12> - Pool's name.
<network_address> - Ip address that DHCP server may assign to
clients.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#config dhcp pool network_addr
engineering 10.10.10.0/24
Command: config dhcp pool network_addr
10.10.10.0/24
Success.
DES-3800:admin#
engineering
404