D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 81

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
config syslog host
Used to configure the syslog protocol to send system log data to a
Purpose
remote host.
Syntax config syslog host [all | <index 1-4>] {severity [informational |
warning | all] | facility [local0 | local1 | local2 | local3 | local4 | local5
| local6 | local7] | udp_port <udp_port_number> | ipaddress
<ipaddr> | state [enable | disable]
The config syslog host command is used to configure the syslog
Description
protocol to send system log information to a remote host.
<index 1-4> − Specifies that the command will be applied to an index of
Parameters
hosts. There are four available indexes, numbered 1 through 4.
all – Specify to configure all Syslog hosts.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently
supported on the Switch.
Numerical
Code
0
1
2
3
4
5
6
7
informational − Specifies that informational messages will be sent to the
remote host. This corresponds to number 6 from the list above.
warning − Specifies that warning messages will be sent to the remote
host. This corresponds to number 4 from the list above.
all − Specifies that all of the currently supported syslog messages that
are generated by the Switch will be sent to the remote host.
facility − Some of the operating system daemons and processes have
been assigned Facility values. Processes and daemons that have not
been explicitly assigned a Facility may use any of the "local use"
facilities or they may use the "user-level" Facility. Those Facilities that
have been designated are shown in the following: Bold font indicates the
facility values the Switch currently supports.
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
77