Route Redistribution Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The route redistribution commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create route redistribute dst ospf src
create route redistribute dst rip src
config route redistribute dst ospf src
config route redistribute dst rip src
delete route redistribute
show route redistribute
Each command is listed, in detail, in the following sections.
create route redistribute dst ospf src
Purpose
Syntax
Description
Parameters
Restrictions
Routing information source − RIP. the Static Route table, and the Local interface routing information. Routing information will be
redistributed to OSPF.
Parameters
[static | rip | local] {mettype [1 | 2] | metric <value 0-16777214>}
[local | static | ospf {all | internal | external | type_1 | type_2 | inter+e1|
inter+e2}] {metric <value 0-16>}
[static | rip | local] {mettype [1 | 2] | metric <value 0-16777214>}
[local | static | ospf {all | internal | external | type_1 | type_2 | inter+e1|
inter+e2}] {metric <value 0-16>}
[dst [rip | ospf] src [rip | static | local | ospf]]
{dst [rip | ospf] | src [rip | static | local | ospf]}
Used to add route redistribution settings for the exchange of RIP routes to
OSPF routes on the Switch.
create route redistribute dst ospf src [static | rip| local] {mettype [ 1 |
2] | metric <value 0-16777214>}
This command will redistribute routing information between the OSPF and
RIP routing protocols to all routers on the network that are running OSPF
or RIP. Routing information entered into the Static Routing Table on the
local xStack switch is also redistributed.
src [static | rip | local] − Allows for the selection of the protocol for the
source device.
mettype [1 | 2] − Allows for the selection of one of two methods of
calculating the metric value.
•
Type-1 calculates (for RIP to OSPF) by adding the destination's
interface cost to the metric entered in the Metric field.
•
Type-2 uses the metric entered in the Metric field without change.
This field applies only when the destination field is OSPF.
metric <value 0-16777214> − Allows the entry of an OSPF interface cost.
This is analogous to a Hop Count in the RIP routing protocol.
Only Administrator or Operator-level users can issue this command.
Route Source
RIP
Static
Local
R R
OUTE
Metric
0 to 16777214
0 to 16777214
0 to 16777214
181
EDISTRIBUTION
Metric Type
mettype 1
mettype 2
mettype 1
mettype 2
mettype 1
mettype 2
25
C
OMMANDS