xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The routing table commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
create iproute
delete iproute default
delete iproute
show iproute
show iproute static
config iproute ospf
ecmp
Each command is listed, in detail, in the following sections.
create iproute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add a single static address 10.48.74.121, mask 255.0.0.0 and gateway 10.1.1.254 to the routing table:
Parameters
[default | <network_address>] <ipaddr> {<metric 1-65535>}{[primary |
backup]}
<ipaddr>
delete iproute [default | <network_address>] {[primary | backup]}
{<network_address> | rip | ospf}
[enable | disable]
Used to create IP route entries to the Switch's IP routing table.
create iproute [default | <network_address>] <ipaddr> {<metric 1-
65535>}{[primary | backup]}
This command is used to create a primary and backup IP route entry to the
Switch's IP routing table.
<network_address> − IP address and netmask of the IP interface that is
the destination of the route. The address and mask information can be
specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in
CIDR format, 10.1.2.3/8).
<ipaddr> − The gateway IP address for the next hop router.
<metric 1-65535> − Allows the entry of a routing protocol metric entry,
representing the number of routers between the Switch and the IP address
above. The default setting is 1.
[primary | backup] - The user may choose between Primary and Backup. If
the Primary Static/Default Route fails, the Backup Route will support the
entry. Please take note that the Primary and Backup entries cannot have
the same Gateway.
Only Administrator or Operator-level users can issue this command.
DES-3800:admin#create iproute 10.48.74.121/255.0.0.0
10.1.1.254 1
Command: create iproute 10.48.74.121/8 10.1.1.254 1
Success.
DES-3800:admin#
R
OUTING
178
24
T
C
ABLE
OMMANDS
Need help?
Do you have a question about the DES-3852 - xStack Switch - Stackable and is the answer not in the manual?
Questions and answers