Layer 2 Fdb Commands - D-Link DES-3852 - xStack Switch - Stackable Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
The layer 2 forwarding database commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
create fdb
create multicast_fdb
config multicast_fdb
config fdb aging_time
config multicast
port_filtering_mode
delete fdb
clear fdb
show multicast_fdb
show fdb
show multicast
port_filtering_mode
Each command is listed, in detail, in the following sections.
create fdb
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a unicast MAC FDB entry:
DES-3800:admin#create fdb default 00-00-00-00-01-02 port 5
Command: create fdb default 00-00-00-00-01-02 port 5
Success.
DES-3800:admin#
Parameters
<vlan_name 32> <macaddr> port <port>
<vlan_name 32> <macaddr>
<vlan_name 32> <macaddr> [add | delete] <portlist>
<sec 10-1000000>
[<portlist> | all] [forward_all_groups |
forward_unregistered_groups | filter_unregistered_groups]
<vlan_name 32> <macaddr>
[vlan <vlan_name 32> | port <port> | all]
{vlan <vlan_name 32> | mac_address <macaddr>}
{port <port> | vlan <vlan_name 32> | mac_address <macaddr> |
static | aging_time}
{<portlist>}
Used to create a static entry to the unicast MAC address forwarding
table (database).
create fdb <vlan_name 32> <macaddr> port <port>
This command will make an entry into the Switch's unicast MAC
address forwarding database.
<vlan_name 32> − The name of the VLAN on which the MAC
address resides.
<macaddr> − The MAC address that will be added to the forwarding
table.
port <port> − The port number corresponding to the MAC destination
address. The Switch will always forward traffic to the specified
device through this port.
Only Administrator or Operator-level users can issue this command.
82
L 2 FDB C
AYER
11
OMMANDS