D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 276

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
Response timeout : 60 seconds
User attempts
DES-3800:admin#
enable admin
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable administrator privileges on the Switch:
config admin local_enable
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the password for the "local_enable" authentication method.
: 5
Used to promote user level privileges to administrator level privileges
enable admin
When the user logins to the device successfully through TACACS /
XTACACS / TACACS+ server or none method, the "user" privilege
level is assigned only. If the user wants to get admin privilege level,
the user must use the "enable admin" command to promote his
privilege level. But when the user logins to the device successfully
through RADIUS server or local method, 3 kinds of privilege level
can be assigned to the user and the user can not use the "enable
admin" command to promote to admin privilege level. When the
Enable Method List is set to TACACS, XTACACS, or RADIUS, the
user must create a special account with the username "enable" in
order to support the Enable Admin function. This function becomes
inoperable when the authentication policy is disabled.
None.
Only when user logins the device successfully though TACACS /
XTACACS / TACACS+ server or none method can use this
command to promote privileges.
DES-3800:admin#enable admin
Password: ******
DES-3800:admin#
Used to configure the local enable password for administrator level privileges.
config admin local_enable
This command will configure the locally enabled password for the enable
admin command. When a user chooses the "local_enable" method to
promote user level privileges to administrator privileges, he or she will be
prompted to enter the password configured here, that is set locally on the
Switch.
<password 15> - After entering this command, the user will be prompted to
enter the old password, then a new password in an alphanumeric string of no
more than 15 characters, and finally prompted to enter the new password
again for confirmation. See the example below.
Only Administrator-level users can issue this command.
DES-3800:admin#config admin local_enable
Command: config admin local_enable
272