D-Link DES-3852 - xStack Switch - Stackable Cli Manual page 223

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
DES-3800:admin#delete ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary
Command:
lsdb_type summary
Success.
DES-3800:admin#
config ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To configure the OSPF area aggregation settings:
DES-3800:admin#config ospf aggregation 10.1.1.1
10.48.76.122/16 lsdb_type summary advertise enable
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Success.
DES-3800:admin#
show ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To display OSPF area aggregation settings:
DES-3800:admin#show ospf aggregation
Command: show ospf aggregation
OSPF Area Aggregation Settings
delete ospf aggregation 10.1.1.1 10.48.76..122/16
Used to configure the OSPF area aggregation settings.
config ospf aggregation <area_id> <network_address> lsdb_type
summary {advertise [enable | disable]}
This command is used to configure the OSPF area aggregation settings.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<network_address> − The 32-bit number in the form of an IP address
that uniquely identifies the network that corresponds to the OSPF Area.
lsdb_type summary − Specifies the type of address aggregation.
advertise [enable | disable] − Allows for the advertisement trigger to be
enabled or disabled.
Only Administrator or Operator-level users can issue this command.
Used to display the current OSPF area aggregation settings.
show ospf aggregation {<area_id>}
This command will display the current OSPF area aggregation settings.
<area_id> − Enter this parameter to view this table by a specific OSPF
area ID.
None.
219